Represents Sidewalks located on the outside edge of the roadway and that run parallel to the route. 1) Begin/End Sidewalk: At the beginning of each road, an initialization point is measured in the center of the road. All sidewalk features for the right and left side of the road are attributed to the initialization coordinates. 2) Attribute Change: At locations where the sidewalk begins, ends, or material changes a point will be measured to denote the change location. If sidewalk change points occur at the same location for the left and right side of road only one set of coordinates will be used to denote the change. 3) Intersections: Sidewalks will be ended at all intersections and large non-network private or commercial entrances. 4) Driveways: Sidewalks will be continuous through driveways. Sidewalks are typed according to material type: concrete, asphalt, paver, brick.